Bug reported for ADAPT-PT 2010 and FAQ’s for ADAPT-Floor Pro

The following has been added to the ADAPT-PT and ADAPT-Floor Pro Pages

1. Bug related to ADAPT-PT 2010 graphical stress report when user-defined load factors are used.  This bug does not affect the general solution.  It only applies to results when viewing stresses for a user-defined case graphically.

2. FAQ added for ADAPT-Floor Pro on how to control spacing of automatically generated design sections for middle strips in RC design.

3. FAQ added for interpretation of reinforcment output for beam support lines in Floor Pro RC.

Add to FacebookAdd to DiggAdd to Del.icio.usAdd to StumbleuponAdd to RedditAdd to BlinklistAdd to TwitterAdd to TechnoratiAdd to Yahoo BuzzAdd to Newsvine

This entry was posted in Uncategorized. Bookmark the permalink.

Comments are closed.