Bug reported for ADAPT-MAT/Floor Pro 2009/2010

A bug has been reported for ADAPT-MAT and Floor Pro when compression only area spring support is used and unbonded PT tendons are present.  The flexural capacity is overly conservative and the reported reinforcement is more than necessary.  Two workarounds are provided.

Add to FacebookAdd to DiggAdd to Del.icio.usAdd to StumbleuponAdd to RedditAdd to BlinklistAdd to TwitterAdd to TechnoratiAdd to Yahoo BuzzAdd to Newsvine

Comments Off on Bug reported for ADAPT-MAT/Floor Pro 2009/2010 Posted in Uncategorized

Videos added for ADAPT-Builder and PT

The following tutorial videos have been added to the Floor Pro/MAT and PT pages.

Floor Pro/MAT:

ADAPT-Builder 2010 Use of Groups for Load Application and Display

Builder 2010 – Top Rebar at Columns when Drop Panels or Caps are Present

PT:

ADAPT-PT 2010 Calculation of Positive Moment Region Minimum Reinforcement for Two-Way Slabs

Comments Off on Videos added for ADAPT-Builder and PT Posted in Uncategorized

Bug reported for ADAPT-Builder

A bug related to the output for two-way shear (punching shear) reinforcement has been added.  Please see the “Bugs & Limitations” page for ADAPT-Floor Pro/MAT for additional information.

Comments Off on Bug reported for ADAPT-Builder Posted in Uncategorized

Bugs reported for ADAPT-PT

Two bugs have been reported for ADAPT-PT.  Please review the “Bugs and Limitations” page for this product for additional information.  The reported bug numbers are 4214 and 4215.

Comments Off on Bugs reported for ADAPT-PT Posted in Uncategorized

Bug reported for ADAPT-PT 2010 and FAQ’s for ADAPT-Floor Pro

The following has been added to the ADAPT-PT and ADAPT-Floor Pro Pages

1. Bug related to ADAPT-PT 2010 graphical stress report when user-defined load factors are used.  This bug does not affect the general solution.  It only applies to results when viewing stresses for a user-defined case graphically.

2. FAQ added for ADAPT-Floor Pro on how to control spacing of automatically generated design sections for middle strips in RC design.

3. FAQ added for interpretation of reinforcment output for beam support lines in Floor Pro RC.

Add to FacebookAdd to DiggAdd to Del.icio.usAdd to StumbleuponAdd to RedditAdd to BlinklistAdd to TwitterAdd to TechnoratiAdd to Yahoo BuzzAdd to Newsvine

Comments Off on Bug reported for ADAPT-PT 2010 and FAQ’s for ADAPT-Floor Pro Posted in Uncategorized